By Noemi Wiley. Furniture. Published at Saturday, June 10th, 2017 - 21:22:52 PM.
Synthetic Rattan Furniture: Synthetic materials are usually regarded with suspicion when it comes to environmental sustainability, even when, as with rattan furniture, this is one of the main selling points employed by manufacturers and retailers.
The same hot iron and gluing method is used in repairing marquetry. Lay a piece of paper over the missing section and rub with a soft pencil to get an outline of the area. Cut the paper to the pattern and stick it to the replacement piece of wood. Cut the wood slightly larger than the pattern and rub down with glass-paper until the exact fit can be obtained. Stick it into place with cold wood glue. On many antique furniture pieces the marquetry tends to lift through age and using the warm iron technique will heat the glue and the raised piece can be gently pressed down back into position. If dust has been trapped under the lifted section, it should be removed, cleaned and re-stuck into position.
Wood veneers can be difficult to match. It is possible to buy new veneer strips, but they are generally thinner than the old hand-sawn veneers and do not always match in colour. It often pays to go to an auction to look for a broken oddment of furniture that has suitable veneers. To remove a veneer from its backing, first clean off any old polish with white spirit and carefully clean the varnish or wax. Place a damp cloth over the cleaned strip and press with a fairly hot iron. Keep the cloth damp. This melts the Scotch glue holding down the veneer, which can then be peeled off. The same technique is used to raise small areas on the antique piece, but use a soldering iron instead of an iron. Wipe all traces of glue while it is still warm. Dampen the veneer and flatten it between two pieces of wood for about 24 hours before use. Do not let it dry completely, for veneers must be re-laid while still damp and pliable. The replacement veneer should be slightly thicker than the existing one, to allow for sanding. Stick the new strip down with Scotch glue and apply a weight or clamp until the glue has completely set. Wax and polish to match the existing finish.
Any content, trademark’s, or other material that might be found on the Easypics website that is not Easypics’s property remains the copyright of its respective owner/s. In no way does Easypics claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
© Copyright 2018 Easypics. All Rights Reserved.